Wire connections – GAI-Tronics 13363 Addressable Amplified Speakers Installation and Operation Manual User Manual
Page 44
Pub. 43004-034F
Model 13353, 13363, and 13373 Addressable Amplified Speakers
Page 39 of 52
e:\radio products-current release\43004\43004-034f\43004-034f.doc
03/15
Wire Connections
The Addressable Amplified Speaker provides terminal blocks inside the rear portion of the housing for
most field wiring. Each terminal block is labeled to indicate the functionality. Refer to Figure 9.
Figure 9.
After routing all necessary cable wires into the Addressable Amplified Speaker, make required wire
terminations at TB101, TB1, and/or TB2 (TB1 and TB2 are located on the rear of the front section, next
to the speaker. Refer to Figure 7 and Figure 19. When connecting to TB101 it is recommended that
spade or ring lug connectors are used.
The following section offers some typical field wiring connection scenarios.