GAI-Tronics 13363 Addressable Amplified Speakers Installation and Operation Manual - Manual (Page 37)

Pub. 43004-034F
Model 13353, 13363, and 13373 Addressable Amplified Speakers Page 32 of 52
e:\radio products-current release\43004\43004-034f\43004-034f.doc
03/15
RF Programming Software
N OTE : Required only for Models 13363 and 13373 (Part of Kit No. 19101-024)
Installation
Exit all other programs that are running until the installation is complete.
Place the CD in the computer CD-ROM drive. If the “auto-run” feature on your CD-ROM drive is
enabled, the Ritron DTXL_PCPS set-up screen should appear within a few seconds.
If the installation does not start up automatically, it can be run from the Start menu. Select the Start
button; then select Run. At the prompt, type x:\fscommand\setup.exe where x represents the drive
letter that is associated with your CD-ROM drive. A DTXL_PCPS icon should appear on the desktop
display after successful installation.
Connecting the Programming Cable
1. Unplug the Addressable Amplified Speaker’s 15-pin D-connector from the radio.
2. Connect the DTXP-PAC cable assembly’s 15-pin D-connector into the radio.
3. Connect the RJ11-style plug of the 9/RTC-PAS cable into the mating receptacle on DTXP-PAC
cable.
4. Connect the DB-9 to DB-25 adaptor to the other end of the 9/RTC-PAS cable.
5. Connect the DB-9 connector of the cable assembly to the computer serial port.
N OTE : If using a USB–to–RS-232 converter, connect the converter to the computer’s USB port and
then connect the cable to the 9-pin mating receptacle on the converter.
6. Connect the red and black leads of the DTXP-PAC cable to a 12–15 V dc source (battery or power
supply), observing the polarity (red +, black-).