GAI-Tronics ITA2000A ITA2000A Series Tone Remote Adapter with Scanning User and Installation Manual - Manual (Page 31)

ITA2000A Series Tone Remote Adapter Installation
27 03/13
Channel Revert (Conventional Mode Only)
Channel Revert allows the ITA2000A to output a certain value on the four channel selection lines after a
transmit is complete from the remote. The value output on the channel selection lines is determined by
switches SW2-5 through SW2-8.
Channel Revert Settings Table
Switch Determines: Up/Down
SW2-4 Whether channel selections are latched
to last decoded frequency, or revert to
a preprogrammed channel (SW2-5 to
SW2-8) after transmit from land line.
Up = Do not revert
Down = Revert based on SW2-5 to SW2-8.
SW2-5
to
SW2-8 The binary representation of the revert
channel.
N
OTE : Revert channel must
correspond to a BCD* code 1 - 15.
Revert to F16 is not possible.
*Binary coded decimal
SW2 SW2
Ch
5 6 7 8
Ch
5 6 7 8
Home     8    
1     9    
2     10    
3     11    
4     12    
5     13    
6     14    
7     15    