FSR ML-800 - Manual (Page 7)

ML-800 7
UNPACKING
Your ML-800 system should contain the following components;
• ML-800RACK (audio control unit) This is the rack unit with the Map/Monitor Panel
• ML-PSA ( large power supply)
• If Wall Plates were ordered Room control panels, one for each room in the system. Depending on the
order either 2 or 3 gang membrane wallplates or touch wallplates will be shipped.
On some installations two wallplates may be required per room.
• If the Facility Manager Panel was ordered you should have an FM-INT Interface Unit, the
RS-232 interconnect cable, a 3.5" diskette, and a power supply. (*)
• If the Remote Audio feed was ordered you should have an enclosed audio speaker along
with special relay cards (116-MNRL and 116-MNP) mounted on a 19 inch
TRAC-BRAC. (*)
• If the Remote Map Panel was ordered you should have the R-MAP Panel with its power
supply.
• If the Remote Monitor Panel was ordered you should have the R-MON Panel which will
mount on top of the R-MAP Panel.
• If the Lutron lighting interface was ordered then you should have the ML-116-INT & power
supply unit.
• This installation Manual.
(*) With multiple ML-800 systems with the FMP or AUX option(s) some duplicate
components are not provided. Please consult factory.