FSR ML-800 - Manual (Page 25)

ML - 800 25
SOURCE
OUTPUT
DEVICE
Input Wiring (single wire with overal shield)
AUDIO CONNECTOR WIRING
In any professional sound system with many inputs and outputs it is strongly recommended that all
audio wiring be balanced. All the audio inputs and outputs on the ML-800 system are balanced.
In a balanced configuration the connectors are wired as follows:
HIGH
LOW
HIGH
LOW
SHIELD
Input Wiring ( two conductor overal shield)
SOURCE
Output Wiring (single wire with overal shield)
Output Wiring (two conductor with overal shield)
OUTPUT
DEVICE
HIGH
LOW
SHIELD
SOURCE
OUTPUT
DEVICE
HIGH
LOW
SHIELD
HIGH
LOW
SHIELD
If due to some equipment limitations unbalanced wiring must be used then the proper way to wire the
audio connectors follows:
HIGH
LO
SHIELD
INSTALL JUMPER HERE (SEE OPPOSITE PAGE)