FSR ML-800 - Manual (Page 15)

ML - 800 13
A
.........There will be two types of wallplates available for use in the ML-800 system; membrane and LCD. Both control
all wallplate functions. These functions include Music Selection, Room Mixer Enable, Music Enable and Volume, and
Local Input On/Off and Volume. Each room in the system can have two wallplates if desired.
B.........
The ML-800RACK (audio control unit) is the main unit of the system. It routes the selected music, adjusts levels,
combines rooms, handles communications (between wallplates, touch map/ monitor panel), and can talk to other ML’s. It
also permits the operation of any wallplate function from this same panel as well as controlling the paging function.
The Monitor function (located in the ML-800RACK) permits an operator to monitor the audio from any selected room.
These two remaining items are described and shown further on in this document.
C.......
This is the R-MAP and R-MONITOR unit that repeats the data on the rack map panel
D......
This is the ML-116-INT unit to handle the lighting interface
ML - 800 SYSTEM BLOCK DIAGRAM
ML-800
BALLROOM
COMBINING
SYSTEM
BMG SOURCE 1
BMG SOURCE 2
BMG SOURCE 3
BMG SOURCE 4
TELEPHONE
PAGE
ROOM 5's AMP
AUDIO
CONTACT FROM PHONE SYSTEM
REQUIRED
OR USE FSR ETA MODULE
ROOM 5's MIXER
ROOM 4's AMP ROOM 4's MIXER
ROOM 3's AMP ROOM 3's MIXER
ROOM 2's AMP ROOM 2's MIXER
ROOM 1's AMP ROOM 1's MIXER
ROOM 8's AMP ROOM 8's MIXER
ROOM 7's AMP ROOM 7's MIXER
ROOM 6's AMP ROOM 6's MIXER
HOME RUN or
DAISY CHAIN
WALL PLATES
Remote MAP and
Monitor
Interface Box
SYSTEM BLOCK DIAGRAM
A
B
C D