FSR ML-800 User Manual
Page 22
ML - 800
23
Wall Plates
Membrane
Size:
6 1/4 inches wide by 4 1/2 inches high, approximately 2.5 inches deep
Mounting:
fits standard 2 or 3 gang electrical wall box with four or 6 screws
Switches:
membrane
Connector:
5 pin connector
Cable:
West Penn #3651 or 3751 (see page 27 for details)
Touch
Size:
6 1/4 inches wide by 4 1/2 inches high, approximately 2.5 inches deep
Mounting:
back box supplied
Switches:
touch panel
Connector:
5 pin connector
Cable:
West Penn #3651 or 3751 (see page 27 for details)
Power Supply (PSA)
Size:
3 1/2 inch high, 6 inches deep, 10 inches long (approximately)
Mounting:
rear rack rail
Input power: 105 to 132 VAC, 50/60 Hz, 100 watts
Output:
+15 volts, +25 volts, -25 volts nominal
Fuse:
2 amp
Switch:
power on/off (lighted rocker switch)
Interconnect: 8 foot cable supplied, 5 conductor stranded
Indicators:
three LED indicators, one for each of the unregulated voltages
FM Facility Manager Control (optional)
Facility Managers Panel (FM-INT)
Size:
an enclosed box 3 1/2 inches wide, 5 inches long, 1 1/2 inches high
Mounting:
sits on the managers desk
Power:
a wall mounted power supply
AUD Audio Monitor Add-on (optional)
Size:
processor card(MNP); 3 1/4 inches wide, 7inches long, 1 1/2 inches high
speaker switching card (MNRL); 3 1/4 inches wide, 9 1/2 inches long, 1 1/2
inches high
Mounting:
both the MNP and the MNRL cards come already mounted in a 19 inch FSR
TRAC-BRAC
Speaker:
enclosed in an attractive baffle 7 inches high, 6 1/2 inches wide, 5 inches deep
R-MAP Remote Map Panel (optional)
Size:
20" wide, 14" high, 2 1/8" deep
Mounting:
standard rack rails
Power:
120 VAC, via knockouts in case