Status diagnosis and repair, Service-codes displayed – Fronius IG 15 User Manual
Page 72

64
After a short time of waiting the FRONIUS IG resumes network synchroni-
zation (message: „SYNC
AC
“).
As long as the power output at the solar modules is insufficient, the dis-
play shows the message „POWER
LOW
“.
Status diagnosis and repair
Service-Codes Displayed
Your FRONIUS IG unit is equipped with a self diagnostic system which
automatically identifies a large number of possible defects by itself and
displays them on the screen. It is thus possible to quickly ascertain de-
fects in the FRONIUS IG unit, in the photovoltaic system as well as instal-
lation and operation errors.
Whenever the self diagnostic system has identified a particular defect, the
respective service code is displayed on the screen.
Note! Display of a service code for a short time may be a result of
the control procedure of your FRONIUS IG unit. If subsequently it
continues to operate normally, there has not been a case of an
error.
Service dis-
play
As soon as the no-load voltage exceeds 150 V, the FRONIUS IG unit
starts synchronizing the network (display shows „SYNC
AC
“).
General ser-
vice codes
As long as the no load voltage of the solar modules is not sufficient, the
screen displays the information „DC
LOW
“.