Foxconn Avenger - Manual (Page 54)

47
3
When PC starts, if �Enabled�� is selected, a Boot Menu will be automatically displayed to inform
you to select a boot device. If no device is selected, the first device will be used. If [Disabled]
is selected, then PC will ask you to press �Esc�� key to get into Boot Menu. This setting simpli-
fies
multiple boot devices user from pressing �Esc�� key to enter boot menu.
► Smart Power LED
Smart Power LED is a feature built on your motherboard to indicate different states during
Power On Self Test (POST). The LED is located at the front panel, and it displays POST state
by different long-short blinking intervals. You can always leave this state enabled.
► Hardware Jumper Selected
When BIOS_SELECT jumper, which is on the motherboard, is set to 1-2 or 3-4, this item will
auto detect power-on boot BIOS.
► Software Item Selecting
When BIOS_SELECT jumper, which is on the motherboard, is set to 7-8, you can select the
power-on boot BIOS by this item. Its default is BIOS ROM 2.
► Auto Detect PCI Clock
This item is used to allow the system to supply the PCI slot bus clock if system detect a PCI
card on the slot.
System Status Power LED Status Stop Blinking Condition
Normal Always On Always On
No Memory Continue blinking On (1sec.), Off (1sec.) Reboot & Memory OK
No Display Continue blinking On (2sec.), Off (2sec.) Reboot & Display OK
Post Error Message
Quick blinking twice (1/3sec. On, 1/3sec. Off),
one long On (1sec.), continuously.
Enter Setup or Skip
No CPU Fan Continue blinking On (1/2sec.), Off (1/2sec.) Reboot & Fan OK