Foxconn Avenger - Manual (Page 33)

26
3
standard CMos features
This submenu is used to set up the standard BIOS features, such as the date, time, floppy drive
and so on. Use the arrow up/down keys to select an item, then use the <+> or <-> keys to change
the setting.
► Date - format
Day—weekday from Sun. to Sat., automatically displayed by BIOS (Read Only).
Month—month from 1 to 12.
Date—date from 1st to 31st.
Year—year, set up by users.
Use , keys to select a field. Use <+>, <->, or to select
a value.
► Time - : : format
This item allows you to configure the desired time. Use , to move forward and
select a field. Directly input a value or use , , <+> or <-> to select a
value.
► SATA Channel 1/2/3/4/5/6, IDE Channel Master/Slave, e-SATA Channel 1/2
These categories identify the hard disks connected to the Intel ® ICH10R and JMicron
controllers in the system. In each channel’s display, you can press �Enter�� to go to its sub- In each channel’s display, you can press �Enter�� to go to its sub-
menu. You can further configure specific drive settings.
�None��, �Auto��, and �Manual��. “None” means no HDD is installed or set; “Auto” means the
None��, �Auto��, and �Manual��. “None” means no HDD is installed or set; “Auto” means the
system can auto-detect the hard disk when booting up; by choosing “Manual” and changing
Access Mode to “CHS”, the related information should be entered manually.
In Access Mode setting, selections of �CHS��, �LBA��, �Large�� and �Auto�� can help you to select
hard drive for legacy compatibility.
Phoenix - AwardBIOS CMOS Setup Utility
Standard CMOS Features
Date (mm:dd:yy) Wed, Jul 23 2008 Item Help
Time (hh:mm:ss) 09 : 44 : 13
Menu Level ►
► SATA Channel 1 WDC WD2500JS-60NCB1
► SATA Channel 2 None Press �Enter�� to enter
► SATA Channel 3 None next page for detail
► SATA Channel 4 None hard drive settings
► SATA Channel 5 None
► SATA Channel 6 None
► IDE Channel Master None
► IDE Channel Slave None
► e-SATA Channel 1 None
► e-SATA Channel 2 ► e-SATA Channel 2 None
Drive A [1.44M, 3.5 in.]
Halt On �All Errors��
Installed Memory 512M
↑↓��������:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help ��������:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help :Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F7:Optimized Defaults
WDC WD2500JS-60NCB1