Dell DPND-523-EN12 - Manual (Page 47)

Connect the Peregrine appliance to AC power | 47
Setup Guide
To attach a keyboard and monitor
1 Following the server installation documentation, connect the output end of
the C2T breakout cable to the C2T (Out) connector on the back of the
Peregrine appliance.
(The C2T breakout cable is packed in the C2T cable kit.)
2 Connect the keyboard and monitor ends of the cable to the keyboard and
monitor.
Connect the Peregrine appliance to AC power
Follow your server installation documentation to connect the AC power and
turn the server on.
Set the BIOS boot sequence
IBM Hardware
Important: For the IBM xSeries 336 and 345, no changes are required for the
BIOS settings.
You must configure the BIOS of the Peregrine appliance to use the correct boot
sequence. (There are slight differences between the procedures for the IBM
xSeries 335 and the IBM xSeries 330).
To set the BIOS boot sequence
1 After you power the server on, wait until the display shows Press F1 for
Configuration/Setup.
2 Press F1.
You see the Configuration/Setup/Utility menu.
3 Use the arrow keys to select Load Default Settings and press Enter.