Dell DPND-523-EN12 - Manual (Page 115)

Making changes to Network Property Groups | 115
Setup Guide
Create a Network Property Group
Add a Network Property Group
1 Administration > Network configuration > Network Property Groups >
Add a Network Property Group.
2 Give your new Property Group a name.
3 Give your new Property Group a description.
4 For each parameter, click On or Off or leave it at the default value, Inherit.
5 Click Submit.
Delete a Network Property Group
You can delete a Network Property Group that no longer meets your needs and
is just cluttering up the list.
Note: Before you can delete a Property Group, you must remove it from any IPv4
ranges to which it has been applied. If the Property Group belongs to a
Property Set that has been applied to a range, you can delete the Property
Group. The Property Set will then set the deleted values to “inherit”.
Delete a Network Property Group
1 Administration > Network configuration > Network Property Groups >
Delete a Network Property Group.
2 Select the Network Property Group you want to delete.
3 Click Select.
4 Click Delete.
Note: You cannot erase default Property Groups.