Step 1: setup your new peregrine appliance – Dell DPND-523-EN12 User Manual

Page 139

Text mode
Original mode

Restoring your data | 139

Setup Guide

Step 1: Setup your new Peregrine appliance

Perform the procedures as detailed in this Setup Guide,

Chapter 5, Install and

Start Network Discovery

. If your new appliance will have the same IP address as

the old appliance, do not connect the new appliance to the network yet. You will
do that later in this process.

Step 2: On your old appliance, do an internal backup

Click Administration > Backup and restore > Run internal backup now.

If you cannot perform this step, you will restore data from the last time the old
appliance did an automatic internal backup (which occurs daily after midnight).

Note:

This action will also initiate an external backup if one has been
configured.