Formax FD 2094 - Manual (Page 38)

34
Forms pull out of burster
tractors. Roller timing is off
Incorrect form length setting
Incorrect feed roller tension
Tractor drive pulley bound up
Tractors binding internally
Tractor pins not centered in
margin holes
Dull slitter blades
Tractor timing is off
Call service.
Reset form length pg. 13
Check and adjust roller tension, Call Service
Check for paper jam and clear, Call service.
Call service.
Adjust tractors pg. 13
Replace blade, Call service
Call service.
Large variations in trim
accuracy
Paper not centered to slitter
feed
Margin slitter setscrew not
tightened down
Realign paper
Tighten setscrew
Snap roller carriage will
NOT move
Defective switch or motor
Broken carriage drive chain
Loose setscrew on carriage
advance shaft or on motor
Obstruction on rack
Obstruction at the pivot arm
Call Service
Call Service
Tighten setscrew, Call service
Remove obstruction
Remove obstruction
Loop forming between
the slitter and the infeed
roller.
Obstruction between the
infeed and snap rollers
Broken fl ow strap
Bent infeed fi nger
Tear bar in low position
Too many tear points
Need Anti-tenting bracket
Remove obstruction
Call Service
Call Service
Put bar in high position pg. 14
Adjust tear points pgs. 13 - 14
Call Service