Formax FD 2094 - Manual (Page 26)

22
STACKER WHEELS
The stacker wheels can be set at any time from the operating
mode by pressing the “STACKER” button.
1. To adjust the stacker wheels, press the “STACKER”
button during operation.
2. Use the “+” and “-” buttons to move the stacker wheels
into position.
Pressing the “+” button will increment the stacker wheels
continuously at slow speed. Holding the “+” button down
for more than 2 seconds will increment the stacker wheels
continuously at high speed until you release the button, or
the stacker wheels reach their outer limit. The system will
track the stacker wheel location and if they reach the stop,
the drive will be disabled and a message will be displayed
for 5 seconds after the “+” is released.
CHANGING DIMENSION SETTINGS
To change dimensions from English to Metric, press the
SET U/M button. Now all the dimensions will be in metric.
The setting will remain until this procedure is repeated.
Pressing the “-” button will decrement the stacker wheels
position at slow speed. Holding the “-” button down for more
than 2 seconds will decrement the stacker wheels position
at high speed until you release the button or the stacker
wheels hit the home position. Once the stacker wheels
have reached the home switch the drive is disabled and
a message will be displayed for 5 seconds after the “-” is
released.
After the stacker wheels are in position press the “ENTER”
button. This will return you to the operating mode.
PAPER JAMS
In the event of a paper jam, the machine will shut off and
display will indicate where the jam occurred.
Any time a jam indication is showing in the display you can
press the STACKER button and the stacker wheels will
move to the end of the table to make it easier to clear any
jammed paper.
Try to determine the cause of the jam and correct it before
pressing the RESET button. Pressing the RESET button
will clear the jam message, return the stacker wheels to
their original position and re-enable the drive.