Formax FD 2094 User Manual
Page 37

33
Forms Creasing
Form is not exiting the folder
straight
Form is not entering the sealer
straight
Creasing continues
Check that the forms are being fed
squarely.
Check that the eight ball track is sitting
properly.
Check to see if the fold rollers are clean.
Check that the eight ball track is sitting
properly.
Call service.
Documents are wrinkled
or crunched
Fold plates are not inserted
correctly
Piece of paper or other material
is stuck in the fold plate
Remove and reinstall fold plates. Be
sure they’re properly positioned.
Remove object from the fold plate.
Forms in burster creep to
one side.
Infeed guides not set properly
Roller tension not uniform
across roller.
Reset Guides, page 12
Check and adjust roller tension, Call
Service
Burster stalls or tears
forms
Tear bar in high position
Burster not running fast
enough
Incorrect form length setting
Tear points not adjusted
properly across face of form
Tough form perforations
Put bar in low position pg. 14
Increase burster speed
Reset paper length pg. 13
Adjust tear points pg. 13
Adjust tear points pgs. 13 - 14
Burster rollers don’t
rotate / machine runs.
Slipped belt
Broken drive belt
Loose pulley
Call Service
Won’t burst properly.
Incorrect roller tension.
Carriage not properly
positioned.
Tear point not set correctly.
Tear bar not set correctly.
Check and adjust roller tension
Call Service
Reset carriage position
Adjust tear points pgs. 13 - 14
Adjust tear bar position pg. 14
Poor slitting.
Slitter blades not making
contact with one another.
Worn blades.
Adjust slitter blade position, pg. 12
Replace blade, Call service