Formax FD 2094 - Manual (Page 23)

RESETTING THE TOTAL COUNT
To reset the total count press the “RESET” button, then
press the “COUNT” button. This also resets the batch
counter, (# of batches & # in the batch).
STARTING PRODUCTION:
After the sheet length and the fold type have been
selected:
1. Start the main drive (press “DRIVE”)
2. Start the pneumatic pump (press “PUMP”).
3. Start sheet (press “SHEET START”)
NOTES: If the wrong “FOLD TYPE” button is pressed, you
can either press the “RESET” button instead of the “ENTER”
button or press the correct “FOLD TYPE” button, then the
“ENTER” button.
After every new set up the machine speed will always be
reset to 60%.
The fold type status LED, when lit constantly, indicates that
the fold plates are set for this type of fold. Any time the folder
is running and a change is made that causes the fold plate
stops to move, the main drive will stop.
COUNTER OPERATION
During normal operation, the display should show the total
count (maximum count 9,999,999), current batch size (3
digits) and the total number of completed batches (5 digits).
This display is known as the count screen.
PROGRAMMING THE BATCH COUNTER
Program the batch counter by pressing the “BATCH SET”
button. The set batch screen will be displayed.
19
1. Using the numerical buttons ( ) enter the desired batch
size; one, two or three digits (maximum setting is 999).
2. Using the “+” and “-” buttons, enter the desired
feed interrupt time (0.3 to 9.9 seconds). This gives the
separation.
3. When stop is displayed, pressing the “SHEET START”
button will feed a batch and stop.
4. Press the “SHEET START” button to process the next
batch.
1. Using the numerical buttons ( ) enter the desired batch
RESETTING THE BATCH COUNTER
To reset the batch counters press the “RESET” button, then
press the “BATCH SET” button. This will reset the batch
count and the total batches. The Total Count will not be
reset.