Formax FD 2094 - Manual (Page 16)

OUTPUT CONVEYOR STACKER ADJUSTMENT
The output stacker has a variable speed control
dial that can be used to adjust the shingle spac-
ing or the space between each form in the stack.
To decrease the space and tighten the shingle,
decrease the speed. To increase the space and loos-
en the shingle increase the speed of the conveyor.
Loose shingle
Tight shingle
Conveyor speed control
Center of slitting blade assembly
Slitting alignment mark
SETUP WITH OPTIONAL SLITTER
1. Set the fold setting on folder. Select from one of the
standard preset folds or set a custom fold if needed.
2. If the slitting alignment mark is not preprinted,
manually fold the form, determine where the slit
should be and mark it for aligning the slitter blades.
3. Using the hand wheel, manually feed the marked
form through the folder into the output wheels of
the folder just before the slitting blades (Fig. 22a).
4. Loosen top and bottom blades of the slitter
with an Allen wrench. Align the center of the
slitter with the slitting alignment mark on the form
(the center of slitter is where the top and bot-
tom slitting blades meet) and tighten into position.
5. Manually fi nish feeding the form and remove.
6. Run a few test sheets to check alignment and adjust
if needed. When the alignment is set begin operation.
Fig. 22a
12