Formax FD 2094 - Manual (Page 11)

7
FEED TABLE ASSEMBLY INSTALLATION - 2094
(NOTE: For 2084, skip this process and go to page 8.)
1. Insert the feed table with the feed wheel toward the
fold rolls.
2. Slide the paper feed table over both sets of locating
pins. The fi rst notch in the front part of the feed table
should rest on the pins (Fig. 9a).
3. Drop the rear notch down on the upper dowel pins
(Fig. 9b).
4. Rotate the hand wheel to check that the gears are
properly meshed (Fig. 10).
5. Connect the feed table hoses. Push the fi ttings into
the holes in the manifold block (Fig. 11).
6. Plug the feed table into the side of the frame. (Fig.
12)
NOTE: Do not operate machine without feed table in
place.
Fig. 11
PUMP HOSE CONNECTIONS: Two sets of hoses
are included with your 2094, two (2) for the feed two (2) for t two (2) for t
table and two (2) for the pump.
Pump
Hoses
Air Vacuum
Feed Table
Hoses
Feed Table Connector
USE OF THE HAND WHEEL: The hand wheel is
used to help clear jams and for setup. To use the
hand wheel, shut off the folder, pull out the hand
wheel and turn it in either direction.
Fig. 10
Hand Wheel
Fig. 12 Fig. 9b
Fig. 9a
Locating
Pins
Locating
Pins