beautypg.com

Operation - 2094 – Formax FD 2094 User Manual

Page 14

background image

10

FEED TABLE SIDE GUIDE ADJUSTMENT

In order for your machine to fold squarely, it must be

fed into the rollers square. On the paper feed table

there are two guides which keep the stack of paper

properly aligned for feeding into the folder. (Fig. 18).

Adjust these guides to correspond with the different

widths of paper being processed.

1. To adjust the paper feed guides, loosen the two side

guide locking knobs on each guide.

2. Slide the guides from side to side until the inside edge

of each guide is aligned with the number corresponding

to the width of the paper being folded. Example: For a

10cm wide sheet, move the side guides until the inside

edges align with the “10” on the feed table.

3. An additional check is to lay a sheet of paper on the

feeder, close to but not touching the side guides. Push

the sheet down into the nip of the fold rolls.

4. Next, loosen the adjusting knobs and align the guide

so it’s parallel to the edge of the paper. When one side

is square, the other side can be moved into position.

5. Tighten the locking knobs to secure the paper guides

in position.

NOTE: When loading an actual job, you may have to

move these guides slightly to accommodate variations

in sheet size. To feed properly, the paper must slide

freely between these guides.

GAP ADJUSTMENT

1. With the machine running, insert two sheets of paper

between the tab and the sucker wheel. (Fig. 19)

2. Turn the gap knob counterclockwise until there is a

slight drag on the paper.

3. Remove the paper. The correct gap is now set.

Fig. 19

Gap knob

Sucker wheel

Fig. 18

Side guide

locking

knobs

Side guide

adjustment

knob

Skew adjustment

Side

guides

OPERATION - 2094

MAIN POWER/RESET SWITCH

The main power/reset switch (Fig. 17) will completely

shut off all power to the operating system. This will

stop everything immediately.

Main

power

switch

Fig. 17

VACUUM FEED SHEET SEPARATOR

The sheet separator will have to be adjusted for the

weight of paper you are folding. Ideal adjustment

will feed only one sheet without marking the paper

or feeding doubles. Use the following procedure to

get started. Fine tune these adjustments according

to the condition of the paper and the environmental

conditions of your particular work area.

This manual is related to the following products: