Formax FD 2094 - Manual (Page 27)

SHUTTING OFF JAM DETECTORS
NOTE: For optimal function, it is recommended to keep the
jam detectors on.
1. To enter jam detector mode, press the SET JAM button:
2. Use the “+” button to toggle between enable and disable
of the specifi c jam detector. Use “-” button to make no
change.
Display shows:
OR
When the “+” or “-” button is pressed, display shows:
OR
When the “+” or “-” button is pressed, display shows:
23
General Cleaning
Take a few minutes at the end of each day to wipe
off accumulations of paper dust. Cover your machine
when not in use. These practices will keep your
machine clean and in tip-top operating condition.
Fold Roller Cleaning
Keep fold rollers clean. Most folding problems are
the result of material accumulations on the fold rollers.
Although designed to minimize accumulations, over a
period of time, ink and dust buildup will prevent the
rollers from gripping the stock evenly. Rollers must
be cleaned on a regular basis to maintain optimum
folding performance.
Disconnect the power, remove the fold plates and
clean rollers with Formax-approved cleaner designed
for the type of rollers your machine is equipped with.
Turn the rollers with the hand wheel (never attempt to
clean rollers with the machine running). Check rollers
periodically for wear. During normal use, fold rollers
will gradually wear. Worn rollers will be evident by
increased setup times, increased spoilage, inaccurate
folding and inability to control the sheet. If one or more
of these conditions are noted, contact your authorized
Formax folder dealer to inquire about inspection and/
or possible roller replacement.
Sealer Roller Cleaning
Keep sealer rollers clean. Sealing problems may
occur if printer toner builds up on the steel rollers.
Disconnect the power, lift the sealer safety cover and
wipe the rollers down with Formax-approved lint free
cloth and roller cleaner.
Cleaning Filters
The fi lters on the pump should be checked periodically
and cleaned as needed. The fi lters can be reached by
unscrewing the fi lter jars.
Photo Eyes
Occasionally wipe off both photo eyes with a dry
cloth.
Cleaning Fold Stop Guides
The fold stop guides should be cleaned once a week
with a dry cloth to keep the plate moving properly.