Formax FD 2092 - Manual (Page 7)

7. Attach the air hoses from the ends of the pile
guides to the double hose fi ttings of the blower. The
single hose from the sucker wheel fi tting attaches to
the vacuum fi tting (Fig 15a & Fig 15b).
NOTE Make sure all shipping plugs are removed
from the pump openings before attaching the hoses.
4. Make sure the fold plate pins are located in the
guide rails, then lower the plate locks. Place the sound
cover on top of the #1 fold plate (Fig. 12).
5. Install the feed table (follow these steps for
the 2092 for the 2082 skip to steps 5a through
5b on page 5 for transfer table install and burster
attachment). Insert the table between the folder side
frames. Install the feed table so the holes in the side
brackets mate with the mounting holes inside the
folder side frames (Fig 13a). Insert mounting pins
(Fig 13b).
NOTE: Mounting pins should be located in the
UPPER SET of threaded holes.
Locating mounting holes
6. Connect the compressor hoses to the feed
table assembly. The sucker wheel hose threads
through the plastic hose clamp and table support,
underneath the feed table, then onto the end of the
sucker wheel tube (Fig. 15).
Vacuum Fitting
1
2
3
1
2
3
Plastic Hose Clamp
Blower hoses
5
Fig 12
Fig 13a
Fig 14
Fig 15a
Fig15b
Fig 13b