Formax FD 2092 - Manual (Page 23)

Forms Creasing Form is not exiting the folder
straight?
Form is not entering the sealer
straight?
Creasing continues
Check to make sure the forms are being
fed squarely.
Check to make sure the eight ball track
is sitting properly.
Check to see if the fold rollers are clean.
Check to make sure the eight ball track
is sitting properly.
Call service.
Documents are wrinkled
or crunched
Fold plates are not inserted
correctly?
Piece of paper or other material
is stuck in the fold plate?
Remove and reinstall fold plates. Be
sure they’re properly positioned.
Remove object from the fold plate.
Forms in burster creep to
one side.
Infeed guides not set properly.
Roller tension not uniform
across roller.
Reset Guides
Check and adjust roller tension, Call
Service
Burster stalls or tears
forms
Tear bar in high position.
Burster not running fast
enough.
Incorrect form length setting.
Tear points not adjusted
properly across face of form.
Tough form perforations.
Put bar in low position pg. 14
Increase burster speed
Reset paper length pg. 13
Adjust tear points pg. 14
Adjust tear points pg. 14
Burster rollers don’t
rotate / machine runs.
Slipped belt, Broken drive belt,
Loose pulley.
Call Service
Won’t burst properly. Incorrect roller tension.
Carriage not properly
positioned.
Tear point not set correctly.
Tear bar not set correctly.
Check and adjust roller tension, Call
Service
Reset carriage position
Adjust tear points pg. 14
Adjust tear bar position pg. 14
Poor slitting. Slitter blades not making
contact with one another.
Worn blades.
Adjust slitter blade position
Replace blade, Call service
21