Formax FD 2092 - Manual (Page 16)

12. If necessary, adjust form length so that form
starts to burst when perforation is just under tear
points.
NOTE: Tear points can be moved to allow operator
to position them at any location along tear bar. Tear
points should be set between perforations that run
vertically the length of the form. (Fig. 30)
13. The tear bar is adjustable to accommodate
characteristics of various forms. To adjust height
bar must be pushed to compress spring and lift out.
Rotate 180 degrees (turned over) and replaced
making sure that square end of bar locks into
brackets. (Fig. 31, shown in HIGH position)
Fig 30
14
Fig 31