Formax FD 2092 - Manual (Page 24)

Forms pull out of burster
tractors. Roller timing off.
Incorrect form length setting.
Incorrect feed roller tension.
Tractor drive pulley bound up.
Tractors binding internally.
Tractor pins not centered in
margin holes.
Dull slitter blades.
Tractor timing is off.
Call service.
Reset form length pg. 13
Check and adjust roller tension, Call
Service
Check for paper jam and clear, Call
service.
Call service.
Adjust tractors pg. 13
Replace blade, Call service
Call service.
Large variations in trim
accuracy
Paper not centered to slitter
feed.
Margin slitter setscrew not
tightened down.
Realign paper
Tighten setscrew
Snap roller carriage will
NOT move
Defective switch or motor.
Broken carriage drive chain.
Loose setscrew on carriage
advance shaft or on motor.
Obstruction on rack.
Obstruction at the pivot arm.
Call Service
Call Service
Tighten setscrew, Call service
Remove obstruction
Remove obstruction
Loop forming between
the slitter and the infeed
roller.
Obstruction between the
infeed and snap rollers.
Broken flow strap.
Bent infeed finger.
Tear bar in low position.
Too many tear points.
Need Anti-tenting bracket.
Remove obstruction
Call Service
Call Service
Put bar in high position pg. 14
Adjust tear points pg. 14
Call Service
22