Formax FD 2092 - Manual (Page 15)

2082 Operation
7. Close tractor gates and lock tractors by tightening
thumbscrews.
8. If using edge slitters, position alignment mark
where you wish to slit. (Fig. 27)
9. If slitting, be sure that slitter blades are engaged.
This is accomplished by rotating wedger in a
counterclockwise direction as far as they will go
without force. (Fig. 27)
10. Lock edge slitters in place by tightening
thumbscrews clockwise. (Fig. 27)
NOTE: If you do not want to slit, push edge slitters
away from form and tighten thumbscrews.
11. By pressing jog switch in forward position,
advance form through feed rollers until snap rollers
grab the form.
Form Set-up Procedure
1. Turn on the machine. Measure form length.
2. Press the form length switch on the burster to
align the alignment mark with the form length on form
length scale. (Fig. 28)
8-Pin Tractor, OP 8-Pin Tractor, Dr Center Paper Guide
Alignment Mark
Wedger Edge Slitters
Slitter Adjustment
Screw
Fig 27
4. Center leading edge of form at infeed end of the
burster.
Form Length Scale
Alignment Mark
Fig 28
3. Place form stack on pull down tray on front of the
burster.
NOTE: Do not stretch form too tightly between
pins; pins should be centered in margin holes.
5. Position tractors to proper form width by releasing
thumbscrews on top of tractors and sliding tractors to
proper width. Raise tractor gates.
6. Lay margin holes of form over feed pins. (Fig. 29)
Fig 29
13