beautypg.com

Formax FD 2092 User Manual

Page 13

background image

Feeding Paper

NOTE: Set folds with standard copy paper so that

the folds line up with the perfs on the pressure seal

forms.

1. Load a stack of paper onto the feed table. The

stack should be no higher than the side guides , 2”

(51mm). Position the backstop up against the lift.

2. Turn on the air/vacuum pump. The air should float

the bottom of the lift approximately 1/16 to 1/8” (16 to

32mm). Air blast can be controlled by adjusting the

valve located at the end of each side guide (Fig. 24).

2. Turn the hand wheel until the separator tip is

positioned over a solid portion of the sucker wheel,

i.e. between the rows of holes.
3. Place a one inch wide (25mm), double thickness

piece of paper to be folded under the tip of the

separator plate. Lower the separator clockwise (cw)

until there is a slight drag on the paper as it is pulled

from the separator.

4. The vacuum advance knob is located on the side

of the feed table (Fig. 23). Adjusting the knob will

position where the vacuum contacts the stock of

paper. Raising the knob will move the vacuum away

from the lift and toward the rollers (light papers).

Lowering the knob will move the vacuum contact

toward the lift and away from the rollers (heavy

papers).
Horizontal Separator Adjustment
1. Raise the separator (ccw) to avoid marking the

sucker wheel.
2. Loosen knob (ill. 2).
3. As a starting reference, turn the hand wheel until

a set of sucker wheel holes is at the 12 o’clock

position.
4. Adjust separator assembly so that the plate is 1/16”

forward of the 12 o’clock position, measure from the

feed side of the plate.
5. Tighten knob (ill. 2).

11

Fig 23

Fig 24

This manual is related to the following products: