beautypg.com

Formax FD 2092 User Manual

Page 6

background image

8. Install the conveyor nip rollers to sealer. Insert

the spring-loaded end (right side – viewed from rear

of the sealer) of the shaft into the locator hole in the

side frame, compress the spring against the side

frame and swing the opposite end into position in the

other side frame (Fig. 8).

The nip wheels can be adjusted in or out to

accommodate different size forms. This is done by

grasping (Fig. 8) the black slide handle attached to

the shaft and sliding it closer to the sealer or away

from the sealer.

9. Place the eight ball track onto the folder/sealer

transfer deck. Line the notches in the track up with

the studs on the deck and set the deck into place

(Fig. 9).

Eight-ball track

Transfer deck

1. Set the folder on the cabinet and line it up with the

recessed holes. Attach the folder to the cabinet from

the underside with the two screws provided.

Steps for assembling the 2092/2082 folder:

2. Install the #2 (lower) fold plate. Lower the cover and

insert #2 fold plate making sure the pins latch into the

rail guides and tighten the eccentric plate locks. Note:

Both plates have two sets of locating holes in the plate

rails. The fi rst set is used when the plate defl ector is

down, the other when the plate is open (Fig 10).

3. Install the #1 (upper) fold plate (Fig 11).

4

Fig 8

Fig 9

Fig 11

Fig 10

Black Slide Handle

7. Plug one end of the conveyor plug into the conveyor

and the other into the sealer. The conveyor inlet is on

the non operator side of the conveyor and the sealer

inlet is located on the non-operator side of the sealer

outfeed (Fig 7a & 7b).

Fig 7b

Fig 7a

This manual is related to the following products: