Fluke Biomedical IDA-5 - Manual (Page 13)

Infusion Device Analyzer
Safety Information
3
• Avoid possible contamination of reusable components due
to backflow conditions. Some older style infusion devices
may have reusable components that could come in direct
contact with the fluids being pumped. When testing these
types of devices take care to avoid possible contamination
of reusable components.
• Do not use delivery set or components that have been used
for testing for patient infusion.
• Do not connect the Product to a patient or equipment
connected to a patient. The Product is intended for
equipment evaluation only and should never be used in
diagnostics, treatment or in any other capacity where the
Product would come in contact with a patient.
• The Product must be properly earthed. Only use a supply
socket that has a protective earth contact. If there is any
doubt as to the effectiveness of the supply socket earth, do
not connect the Product. Do not use a two-conductor
adapter or extension cord. This will break the protective
ground connection.
• Many components on the printed circuit board are static
sensitive. ESD precautions should be observed when
handling the printed circuit board assembly.
• To avoid shock hazard and for proper Product operation,
connect the factory supplied three-conductor line power
cord to a properly grounded power outlet. Do not use a two-
conductor adapter or extension cord; this will break the
protective ground connection.
• The Product is intended for use by trained service
technicians to perform periodic inspections on a wide range
of medical equipment. The testing procedures are menu-
driven and simple to operate.
• The Product is intended for use with single-phase, grounded
power. It is not intended for dual, split-phase or three-phase
power configurations. But it can be used with any power
system that supplies the correct voltages for single-phase
and is grounded.
• This Product is intended to be used in the laboratory
environment, outside of the patient care area, and is not
intended for use on patients, or to test devices while
connected to patients. This Product is not intended to be
used to calibrate medical equipment and not intended for
over the counter use.