Transport of the pump bowl assembly – Flowserve Byron Jackson Type M User Manual
Page 11
Byron Jackson Double Mechanical Seal Submersible Pumping Unit • 1042.293/9 • June
04
Page 11 of 68
2.
Place a wire around the motor. The wire is to
be positioned between stator and lower cas-
ing, approx. 1/3 from bottom of motor.
Figure 2 Lifting motor for installation
3.
Lift the motor horizontally by 2 points.
4. Transport the motor horizontally to the instal-
lation or storage site.
5. Carefully lower the motor at the respective
site and place it on the floor.
If the motor is to be stored:
•
Continue with Chapter 2.3 "Storage and ship-
ping", Page 12.
If the motor is to be installed in a well:
•
Continue with Chapter 4 "Installation",
Page 19.
If the motor is to be maintained:
•
Continue with Chapter 6 "Maintenance",
Page 50.
2.2.4
Transport of the pump bowl assembly
NOTE Not all components or sub-
assemblies of a pumping unit are
necessarily supplied by Flowserve
or part of this delivery.
These user instructions apply only
to the components or sub-
assemblies supplied by Flowserve
in this delivery, see Chapter 12.1
"Scope of delivery".
CAUTION Use care to prevent bumping, push-
ing, or scraping of pump bowl as-
sembly parts, especially the shafts,
or other machined surfaces.
Take precautions to prevent foreign
materials or dirt from entering the
working parts of the pump bowl as-
sembly.
NOTE
The following description refers to
pumps without auxiliary carriers.
Should the pump be delivered on an
auxiliary carrier, refer to the pump
manual for transportation instruc-
tions.
1.
Connect the pump
•
directly to the hoists, or
•
to the cross-beam
of a portable crane.
2.
By means of the crane, carefully lift the pump
and move it to the desired site.
If the pump bowl assembly is to be stored:
•
Continue with Chapter 2.3 "Storage and ship-
ping", Page 12.
If the pump bowl assembly is to be installed in a
well:
•
Continue with Chapter
If the pump bowl assembly is to be maintained:
•