ETA Gratus Maxipasta - Manual (Page 50)

Then slide the mould D8 with various dough profi le shapes on to the holder D7. Install the
assembled meat mincer on to the multi-function head according to the procedure in point 1.
Now the appliance is ready to prepare shaped dough. To disassemble proceed in the
reverse sequence. To disassemble the entire meat mincer press the release button A5, turn
the meat mincer clockwise and pull it out of the multi-function head mount.
Application
Place the prepared dough into the meat mincer‘s fi lling funnel D14. If necessary use the
pusher D13 to push the dough into the meat mincer D. The appliance will press out the
dough in the desired set shape. Insert the power cord plug A11 into a power socket. Put the
appliance into operation by turning the speed dial A2 to one of the speed levels appropriate
for pressing out dough.
Recommendation
– We recommend that you hold (support) the pressed dough in the desired shape with
a plate so that it does not tear.
– Cut the shaped dough to shorter lengths of approx. 5-7 cm.
– The processing takes several minutes and depends on the amount, type and quality
of the dough used.
i
Cutter/grater for vegetables and fruit (E)
Assembly and installation on the multi-function head (pic. 3 and 7)
Remove the fastening nut E5. Insert an appropriate attachment (E1 to E4) into the cutter
E according to the desired cutting or grating coarseness and secure the attachment by
screwing the nut on to the cutter. Slide out the cover A6, insert the cutter E into mount A4
of the multi-function head A7 at an angle of approximately 45 o and secure in a horizontal
position by turning it anticlockwise (you will hear a click).
Now the appliance is ready for cutting/grating. When changing the attachments, proceed in
the same manner. To disassemble the cutter press the release button A5, turn the cutter
clockwise and pull the cutter out of the multi-function head mount.
Application
Cut the vegetable into pieces appropriate for insertion into the cutter opening E. Insert the
pieces into the cutter E and carefully push down using the pusher E6.
Note: Never press cut vegetables with your fi ngers!
Insert the power cord plug A11 into a power socket. Put the appliance into operation by
turning the speed dial A2 to one of the speed levels appropriate for the cutting of vegetables
and fruit.
Recommendation
– Remove the peel from citrus fruits.
– If the cutter E becomes clogged, it is necessary to turn off the drive unit and
to disassemble the cutter body and to clean it out.
– The processing takes several minutes and depends on the amount, type and quality
of the fruit and vegetables used.
i
50
GB
/ 90