Drake EEG-QIP Enterprise Edge Guide with QAM and IP Input / CHIC Software - Manual (Page 9)

9 937.746.4556 | www.rldrake.com
FRONT PANEL
1. Ethernet Control: 10/100 Ethernet wired connection for local and remote management
2. IP Reset Button: When pressed for >2 seconds, the IP address of the control port will enable to the default factory IP
address (
172.16.70.1 , Subnet Mask 255.255.255.0) The login credentials will also be enabled to the default username
Admin and password pass.
Note: The old IP address, login, and password will still be present in the encoder settings.
3. Status LEDs: Provides a status of tasks performed by the EEG-QIP encoder in real-time:
Status: The LED is illuminated when input video is being received from the specified input. If Status LED is Red,
then the input QAM is not locked. If the Status LED is flashing Green, then the QAM is locked but no DSM-CC
data has been received for at least 30 minutes. If the Status LED is Solid Green, then the QAM is locked and
EEG-QIP is receiving Guide data.
Power: The LED is illuminated when the power is ON.
REAR PANEL
QAM Input: QAM input source
+12VDC Power Port: Accepts twelve-volt power to the device
QAM Output: QAM output
Audio/Video In: Left and Right Audio and Digital Video in
1
2
3
4
5
6
Front and Rear Panel Operation
1 2
4 5 6 3