Drake EEG-QIP Enterprise Edge Guide with QAM and IP Input / CHIC Software - Manual (Page 12)

12 937.746.4556 | www.rldrake.com
TS Config Screen
The “Main > TS Config” screen is a “read and write” screen to assign the TS parameters:
TS ID: must enter the identification number for the Transport Stream (TS) output. The range is 1 to 65535.
TS Bitrate: must select the bitrate for the output TS. Possible options are QAM Modulator, 19.39 Mbps, and 38.81
Mbps.
Modulation Mode: select the modulation mode. Possible options are: Reserved, Analog, QAM64, QAM256,
8-VSB, and 16-VSB.
Out of Band: An out-of-band (OOB) is a channel which is the combination of the forward and reverse OOB
channels. When a cable virtual channel is flagged as being out-of-band, it is carried on the out-of-band channel.
Possible options are Enable and Disable. When Enabled, assigns the OOB bit in the TS packet and labels the TS
as out-of-band.
Input: indicates the program selected by the user. It includes the Input video source and audio source.
PID: must enter the PID value for each stream. PID (Packet Identifier) values are embedded by the content
provider in the MPEG-2 stream to identify tables and programming packets.
Program Number: must enter an output program number. PMT (Program Map Table) provides information of
program present in the transport stream such as program number, and the list of the elementary streams (audio,
video or data). The range is 1 to 65535.
Short Name: A short name of the channel can be assigned. Up to 7 alphanumeric characters are allowed.
Major Channel: must enter the major channel number for the output program. The range is 1 to 99 for Terrestrial
and 1 to 999 for Cable.
Minor Channel: must enter the minor channel number for the output program. The range is 0 to 99 Terrestrial and
0 to 999 for Cable. 1
2
3
4
5
6
7
8
9
10
1 2 3 4
8 5 6 7 10 9
NOTE: Be sure to Save entries.