Chapter 6, Troubleshooting, Troubleshooting table – DR Power Z-Mower 19.5 HP Versa-Pro User Manual
Page 49
CONTACT US AT
www.DRPower.com
or CALL TOLL FREE 1-800-DR-OWNER 45
CHAPTER 6
TROUBLESHOOTING
Most problems are easy to fix. Consult the Troubleshooting Table below for common problems and their
solutions. If you continue to experience problems call Country Home Products, Inc. for support.
Troubleshooting Table
WHEN PERFORMING ANY ADJUSTMENT OR MAINTENANCE, YOU MUST FIRST SHUT OFF THE ENGINE,
SET THE PARKING BRAKE, WAIT FIVE (5) MINUTES TO ALLOW PARTS TO COOL AND DISCONNECT THE
SPARK PLUG WIRE(S), KEEPING IT AWAY FROM THE SPARK PLUG(S).
S
YMPTOM
P
OSSIBLE
C
AUSE
The Engine will not
start.
(Please refer to the
Engine Owner’s
Manual for Engine-
specific procedures.)
⇒ Check all the items under the section called Starting the Engine on page 18.
⇒ Check that the Control Handles are in the Neutral position.
⇒ Make sure the Spark Plug Wire(s) is attached.
⇒ Make sure the Throttle is in the Start position and the Choke is pulled out.
⇒ Check the oil and gas level. See page 15.
⇒ The gas may be old, change it. Use a fuel stabilizer if you keep gas longer than
one month.
⇒ The Spark Plug(s) may be dirty or cracked, change it. If it is oily, leave it out, hold
a rag over the Plug Hole(s) and crank the Engine several times to blow out any
oil in the cylinder(s), then wipe off the Plug(s) and reinsert it.
⇒ Check the Fuel Filter, it may be clogged. Replace if necessary.
⇒ The Air Filter may be dirty, change it following the procedure in the Engine
Owner’s Manual.
⇒ Check the wire connections—especially the ground connection, the large black
wire coming from the Battery, where it connects to the Engine.
⇒ Check the wire connections to the solenoid. Disconnect the black Battery ground
wire first to avoid sparks. Check to be sure that all of the connections are clean
and tight. Reconnect the Battery ground wire.
⇒ Check the ground connection on the Solenoid where it bolts to the Frame. Using
a wrench or socket, tighten the Bolts to ensure a good connection to the Frame.
⇒ The Battery may not be charged. Check the voltage yourself or at a service
station. If it is low, charge it with a 12-volt, 1 to 2 amp trickle Charger. If you do
not use your machine for at least 45 minutes at a time, the Battery may need to
be periodically charged. See the Battery care section on page 41.
⇒
If the Battery is charged and the Engine still will not start, visit our website at
www.DRPower.com
or call 1-800-DR-OWNER (376-9637) for assistance.