DR Power Z-Mower 19.5 HP Versa-Pro - Manual (Page 29)

CONTACT US AT www.DRPower.com or CALL TOLL FREE 1-800-DR-OWNER 25
CHAPTER 5
ADJUSTING AND MAINTAINING THE DR VERSA-PRO Z-MOWER
This chapter covers adjustments and regular maintenance procedures that will ensure the best performance
and long life of your machine. Your DR VERSA-PRO Z-MOWER was fully adjusted at the factory and should
stay in adjustment. However, should you notice changes in how the machine operates over time; the
following procedures will provide the needed adjustments.
For Engine maintenance, please refer to the
Engine Owner’s Manual that came with your Mower. Service intervals listed in the checklist below
supercede those listed in the Engine Owner’s Manual.
WHEN PERFORMING ANY ADJUSTMENT OR MAINTENANCE, YOU MUST FIRST SHUT OFF THE ENGINE,
SET THE PARKING BRAKE, WAIT FIVE (5) MINUTES TO ALLOW PARTS TO COOL AND DISCONNECT THE
SPARK PLUG WIRE(S), KEEPING IT AWAY FROM THE SPARK PLUG(S).
Regular Maintenance Check List
NOTE: Consider the service intervals shown as maximum under normal operating conditions. Increase
frequencies under extremely dirty or dusty conditions.
Procedure
Before
Each
Use
Every 10
Hours
Every 25
Hours
Every 50
Hours
Every 100
Hours
Every 500
Hours
Check Operator Presence Switch ▲
Check Engine Oil Level ▲
Check Hydraulic Oil Level ▲
Check General Condition, e.g.
nuts, bolts, welds, etc. ▲
Check Blade Sharpness ▲
Clean Engine Exterior and
Cooling Fins ▲
Lube Spindles & Front Wheels ▲
Check Battery Voltage ▲
Check Cable connections ▲
Check Deck Level ▲
Check Tire Pressure ▲
Clean Air Filter & Recliner ▲