DR Power Tow-Behind 9.00 Commercial (May 2006 - July 2010) - Manual (Page 27)

CALL TOLL-FREE 1-800-DR-OWNER 23
Connecting the Blower Inlet Vacuum Hose to the Hose Adapter
The following procedure includes the steps necessary for connecting the Blower Inlet Vacuum Hose of the
DR LEAF and LAWN VACUUM to the Hose Adapter.
Tools May Be Needed:
•
Wire Cutters or Hack Saw
• Knife
•
Screw driver or Nut driver
1. Connect the Hose from the Blower Inlet to the Hose Adapter by aligning the two (2) Flexible
Latches and slipping the end of the Hose over the Adapter (Figure 22).
2. Pull and hook the two (2) Flexible Latches into place (Figure 22) to secure the Hose.
Tip: If the Latches do not align, loosen the Hose Clamp on the Inlet Hose and rotate the Hose
Connector into alignment.
Hose Adapter
Inlet Hose
Pull and Hook
Flexible Latch
Figure 22
Hose Clamp