DR Power Tow-Behind 9.00 Commercial (May 2006 - July 2010) - Manual (Page 21)

CALL TOLL-FREE 1-800-DR-OWNER 17
Figure 12
5. Attach the Front Enclosure Panel on the protruding Support Pins and fasten the Sides, Top, and
Bottom using the six (6) Flexible Latches (Figure 12). The mounting holes are located on top of the
Panels.
Tip: For ease of attaching the Front Box Cover, pull the Dump Lever and tilt the Body back. Set the
Front Box Cover over the protruding Pins, one side at a time, making certain that the six (6)
Flexible Latches are on the outside of the Panels (Figure 12).
6. Lower the Bed until locked in place with the Dump Lever (Figure 8 on page 15). Attach the Rear
Panel on the protruding Pins and secure in place with the six (6) Flexible Latches (Figure 13).
Tip: Set the Rear Panel over the protruding Pins, one side at a time, making sure to keep the Flexible
Latches on the outside of the Box.
Figure 13
Attach over Pins
Flexible Latches
6 places
Tilt Bed Back
Attach over Pins
Flexible
Latches
6 places