DNF Controls USP-S - Manual (Page 12)

Page 12 of 27
8. ETHERNET TRANSMIT ACTIONS Configuration Web Page
Action Label Enter any 32 characters. This label is for convenience only and is used in the Event Action
Table.
ASCII/ HEX
Command
The ASCII/HEX Command is 1 - 256 characters in length.
Use %yz to enter a HEX value. ‘y’ and ‘z’ are values 0 - 9 or A- F. Two characters must
follow %.
Use %WTttt to add a WAIT time, 001 - 999 milliseconds. Three numbers must follow %WT.
The characters preceding %WT are sent immediately. The characters after %WTttt are sent
after the wait time expires. More than one %WT can be included in a command. NOTE- %WT
is only an approximate wait time.
NOTE- Spaces between characters are NOT transmitted. Use %20 to transmit a space
character.
NOTE
- For UDP Ethernet Transmit Actions, the USP-S uses source port 50000