DNF Controls AnyWhere Interface Switch - Manual (Page 8)

Page 8 of 20
5. REMOTE DEVICE LIST Configuration Web Page
The AnyWhere Interface Switch (AIS) will transmit commands to and receive commands from the
Remote Devices listed on this web page. If a Remote Device is not listed on this page, the AIS will
not send commands to that device, nor will it accept commands from that device.
Remote Device Label Enter any 32 characters. Device label is displayed on Switch Configuration and Tally
Configuration web pages.
Device Type EXT Tally- ONLY for a Remote Device that will be using the AIS’s EXT Tally protocol to
control AIS key legend and key color.
GTP/DC - Connect to DNF Controls GTP-32 and DC20 devices
USP - Connect to DNF Controls USP devices
Otherwise, set to ‘------‘.
Connection Type For Device Type ‘------‘
Select UDP or TCP/IP
Connection Mode For TCP/IP Only
Client Transmit: Establish connection to remote device.
Transmit command.
Disconnect from remote device.
Client Transmit/Receive: Establish connection to remote device.
Maintain connection to remote device.
Server Receive/Transmit: Accept connection from client.
Only client at assigned IP Address can connect
The client is responsible for maintaining connection.
Server Mode only, AnyWhere Interface Switch listens on the following ports:
Port 50001 for connection from Remote Device 1
Port 50002 for connection from Remote Device 2
Port 50003 for connection from Remote Device 3
Port 50004 for connection from Remote Device 4