DNF Controls AnyWhere Interface Switch - Manual (Page 13)

Page 13 of 20
Data
For Local Device:
Local GPO ON GPO#
Local GPO OFF GPO#
Local GPO Toggle GPO#
Set Switch #1 to Step# Step Number
Set Switch #2 to Step# Step Number
Set Switch #3 to Step# Step Number
Set Switch #4 to Step# Step Number
Pause Wait time: 0.25 seconds to 10 seconds
For Remote Device:
GTP/DC:
Key Press
Key Release
GPO Status
Key number 1 - 16
Key number 1 - 16
GPO number 1 – 4
USP:
Key Press
Key number 1 – 16
EXT Tally:
Transmit Command
ASCII/ Hex command
Other:
Transmit Command
ASCII/ Hex command
ASCII/ Hex
Command
An ASCII/HEX Command is 1 - 200 characters in length.
Use %xy to enter HEX value. x and y are values 0 - 9 or A- F. Two characters must
follow %.
Use %WTttt to add WAIT.
Transmit command characters to the left of %WT. Wait ttt time, 001 - 999 milliseconds.
Transmit next part of command or rest of command.
NOTE-%WT is only an approximate wait time.
NOTE- Spaces between characters are NOT transmitted.
Use %20 to transmit a space character.
Use %22 to transmit a single quote character (").
Use %27 to transmit a double quote character (').