View the clip id of the currently loaded clip, Learn, Recall – DNF Controls 4000CL-TO User Manual
Page 8

8
4000CL-TO, 400 Clip Fast Access System, PinnacleThunder Protocoll
7.
VIEW THE CLIP ID OF THE CURRENTLY LOADED
CLIP
Press and hold [SHIFT], then press and release [LOAD].
The bottom line will show: “Loaded Clip: xxxxxxxx” where xxxxxxxx = CLIP ID.
8.
LEARN
a.
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by manually
entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
b.
LOAD a clip (see previous section).
c.
Press [SHIFT] + [MARK] to start the LEARN.
The display shows:
d.
Press VTR [1], [2], [3] or [4] to select the VTR to be learned into the Cue Point.
If the VTRs are ganged, select one VTR that is part of the Gang. The rest of the Gang
will learn automatically.
e. Press
[MARK] to complete the LEARN.
OR
Press [ESC] to exit without LEARNING.
The ST300 will: LEARN (save) the VTR Number (1,2,3,4), loaded CLIP ID and current
IN time to the selected Cue Point.
9. RECALL
a. Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE]
or by manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
b. Press
[LOAD] on the ST300.
The ST300 will automatically load the Learned clips on the Learned VTRs, cue the clips
to the Learned time, then set the Learned GANG mode.
Select VTR:
Mark-Learn, ESC-Cancel