DNF Controls 4000CL-TO - Manual (Page 7)

7 4000CL-TO, 400 Clip Fast Access System, PinnacleThunder Protocoll
4. VIDEO SERVER SETUP
Select ODETICS Broadcast Communications protocol on the VIDEO SERVER to be controlled.
If required, assign a serial port on the VIDEO SERVER through which the ST300 will control it.
NOTES: The VIDEO SERVER may not support LTC or VITC time modes in ODETICS
Broadcast mode. The ST300 will default to Tape Time if a non-supported mode is selected.
In ODETICS Broadcast mode, the VIDEO SERVER may only allow Full Record.
INSERT and ASSEMBLE record modes may be disabled.
5. LOAD AND PLAY A CLIP
a. Press
[CLIP LIST] to view the list of Clips that exist in the VIDEO SERVER. The
display will show “CREATE NEW CLIP.”
b.
Turn the Wheel. The top line of the display will show “xxxxxxxxx:”
Where “xxxxxxxx” is the eight-character CLIP ID.
Turn the Wheel clockwise to scroll forward, or counter-clockwise to scroll backward,
through the list of available Clips.
OR
Manually enter a CLIP ID from the ST300 numeric keypad.
c. Press
[LOAD] to load the current CLIP ID shown on the top line of the display.
d. Press
[PLAY].
6. RECUE THE CURRENTLY LOADED CLIP
a. Press
[RECUE] to recue the Clip to its beginning.
(In RECALL mode, [RECUE] will recue to the user defined time.)
OR
Press [SHIFT] + [RECUE].
The display will show: “xx:xx:xx:xx” (xx:xx:xx:xx = last entered RECUE time)
“Enter RECUE time”
Enter the desired time to search to using the ST300’s numeric keypad.
b. Press
[ENTER] to search to the entered time.
OR
Press [ESC] to exit without searching.