DNF Controls 4000CL-TO - Manual (Page 10)

10 4000CL-TO, 400 Clip Fast Access System, PinnacleThunder Protocoll
11. PLAYING SINGLE CLIP IN LOOP OR PLAY-TO-
LOOP MODES
a. LOAD the clip. (The clip MUST be loaded from the DNF Controller.)
b. Set the IN and OUT points. (See CAPTURE FUNCTION section.)
c. Press [PTL] or [LOOP ENABLE].
d. Hold [SHIFT] and press [RECUE].
e. Enter the starting point of the LOOP or PTL, then press [ENTER].
f. Press [PLAY].
g. To clear the IN or OUT points, hold [DEL] and press [IN] or [OUT].
12. LEARN PLAY-TO-LOOP INTO CUE POINT
Follow steps a and b above to LOAD a clip and set the IN and OUT points; press [PTL].
a.
Select a Cue Point by pressing [LAST CUE], [NEXT CUE] or
using the numeric keypad.
b. Press
[SHIFT] + [MARK].
c.
Press the VTR number you wish to learn the Cue Point into.
d. Press
[MARK].
13. THE RECUE FUNCTION
If the IN or OUT time is being displayed, the clip will RECUE to that IN or OUT time.
If the IN or OUT time is not displayed, the clip will RECUE to the start of the clip.
NOTES:
‰ All transport modes, other than PLAY, are disabled when LOOP ENABLE is ON.
‰ When saving a Cue Point and no IN point is set, the current clip location will be used as the
IN point.
‰ There MUST be at least 4 seconds between the IN & OUT points for any LOOP
COMMAND.