DNF Controls 4000CL-TO - Manual (Page 14)

14 4000CL-TO, 400 Clip Fast Access System, PinnacleThunder Protocoll
16. TRANSFERRING CUELIST
The TRANSMIT CUELIST function allows you to transmit your list of Cue Points to a PC, using
the provided utility software on the PC, or to another ST300. Transfer to a PC requires OpSuite
3.0 software, which runs on a Windows-based computer. Contact DNF Controls for more
information.
a. TO TRANSMIT CUE POINTS TO THE ST300
1)
Connect the VTR 4 connector on the rear of the ST300 to the VTR4 connector
of the receiving ST300 using an RS422 9-pin cable with TX and RX lines
crossed.
(A “turnaround” cable)
2) Press
[MENU].
3)
Scroll the Wheel until “Transmit CUE List? YES=Enter, Exit=ESC” is
displayed.
4) Press
[ENTER] to start transmitting.
The Display shows “Waiting to transmit” on the first line.
5)
When the Receiver is ready, transfer starts automatically.
The Display now shows “Transmitting cuelist.”
6)
After the transfer is over the display shows “Transfer is over” for one second,
then shows “Waiting to transmit” again.
7)
Connect another ST300 to transmit the list again.
OR
Press [ESC] twice to exit.
b. TO TRANSMIT CUE POINTS TO THE PC
1)
Connect the VTR4 connector on the back of the ST300 to one of the COM ports
on the PC using an RS422 to RS232 adapter.
2)
Repeat steps 2-7 of TO TRANSMIT CUE POINTS TO THE ST300 section.