Switching between hd and tape – DNF Controls 2034CL-SX User Manual
Page 8
8
2034CL-SX, 300 Clip Instant Access System, Sony SX Protocol
SWITCHING BETWEEN HD and TAPE
Switching between tape and HD, press [TAPE] to assign control to the Tape or the HD.
If the LED above [TAPE] is on you are controlling the tape drive. The time code on the ST300’s
display is the tape drives’ time code and the video signal comes from Tape, (assuming SX
operation mode is set to Player = Tape, Rec = Disk or Player = Disk, Rec = Tape).
If the LED above [TAPE] is off, you are controlling HD; Time Code and Video you are
monitoring come from the HD. NOTE: The Clip List function is not available on the Tape drive.
When you LEARN on the HD, the CLIP ID, time and data are stored in the Cue Point.
When you do a LEARN and the Tape is active, only current Timecode and Gang data are
stored in the Cue Point.