Reference, Function table – DNF Controls 2034CL-SX User Manual
Page 20

20
2034CL-SX, 300 Clip Instant Access System, Sony SX Protocol
Reference . . .
15. FUNCTION
TABLE
Function
Key Press
Description
GOTO ENTERED
TIME
[SHIFT] + [RECUE]
Search the VTR to the manually entered time
OR use the ST300 numeric keypad, then press [ENTER] or
[RECUE].
FFWD
[FFWD]
Press and HOLD to shuttle. Release key to stop. Set WIND
Speed in MENU.
JOG [JOG]
Select JOG mode and enable Wheel.
LAST CUE
[LAST CUE]
Step to the previous Cue Point Location.
NEXT CUE
[NEXT CUE]
Step to the next Cue Point Location.
RECORD [REC]
Places VTR into the Record mode selected by RECORD
MODE in the SETUP MENU. Press [RECORD] or
[RECORD] + [PLAY]. (See SETUP MENU.)
REWIND
[RWD]
Press and HOLD to shuttle. Release key to stop. Set WIND
Speed in MENU.
SHUTTLE [SHUTTLE]
Select SHUTTLE mode and enable Wheel.
SLOMO
[SLOMO] Press
[SLOMO] to slo-mo the VTR. Turn the Wheel (or
move the T-Bar, if available) to change the play speed.
Press [SLOMO] to STILL frame
OR press any transport key to exit SLOMO.
SLO-MO SPEED
PRESET
[SHIFT] + [SLOMO] For
WHEEL
ONLY: Press [SHIFT] + [SLOMO] to preset
the slo-mo speed. Turn the Wheel to select desired speed.
Press [ESC] or any transport key to exit.
STOP [STOP]
Press once to STILL frame VTR.
Press again to put VTR into STOP mode.
TIME MODE
SELECT
[TIME MODE]
Press to toggle between Timecode (TC), VITC (VT) or Tape
Timer (TM) display modes.