Shotbox shotkey maps, Shotbox control switches, Transferring cuelists – DNF Controls 2034CL-SX User Manual
Page 15: A. transmit cue list function
15
2034CL-SX, 300 Clip Instant Access System, Sony SX Protocol
11. SHOTBOX SHOTKEY MAPS
The SWITCHES on the SHOTBOX access the SHOTLIST locations as follows:
BANK 0, SWITCHES 1 Î 30 access SHOTLIST locations 001 Î 030.
BANK 1, SWITCHES 1 Î 30 access SHOTLIST locations 101 Î 130.
BANK 2, SWITCHES 1 Î 30 access SHOTLIST locations 201 Î 230.
BANK 3, SWITCHES 1 Î 30 access SHOTLIST locations 301 Î 330.
BANK 4, SWITCHES 1 Î 50 access SHOTLIST locations 401 Î 430.
BANK 5, SWITCHES 1 Î 30 access SHOTLIST locations 501 Î 530.
BANK 6, SWITCHES 1 Î 30 access SHOTLIST locations 601 Î 630.
BANK 7, SWITCHES 1 Î 30 access SHOTLIST locations 701 Î 730.
BANK 8, SWITCHES 1 Î 30 access SHOTLIST locations 801 Î 830.
BANK 9, SWITCHES 1 Î 30 access SHOTLIST locations 901 Î 930.
12. SHOTBOX CONTROL SWITCHES
a.
[PLAY]: Plays out the selected clip.
b.
[RECUE]: Returns to the beginning of the clip.
c.
[STOP]: Stops playout of the clip.
13. TRANSFERRING
CUELISTS
a.
TRANSMIT CUE LIST FUNCTION
The TRANSMIT CUELIST function allows you to transmit your list of Cue Points to a
PC, using the provided utility software on the PC, or to another ST300. Transfer to a PC
requires OpSuite 3.0 software, which runs on a Windows-based computer. Contact DNF
Controls for more information.
1)
To Transmit Cue Points to the ST300
a)
Connect the VTR 4 connector on the rear of the ST300 to the VTR4
connector of the receiving ST300 using an RS422 9-pin cable with TX
and RX lines crossed. (A “turnaround” cable)
b) Press
[MENU] and scroll the Wheel until
“Transmit CUE List? YES=Enter, Exit=ESC” is displayed.
c) Press
[ENTER] to start transmitting.
The Display shows “Waiting to transmit” on the first line.
d)
When the Receiver is ready, transfer starts automatically.
The Display now shows “Transmitting cuelist.”
e)
After the transfer is over, the display shows “Transfer is over” for one
second and then shows “Waiting to transmit” again.
f)
Connect another ST300 to transmit the list again
OR press [ESC] twice to exit the MENU mode.