DNF Controls 2034CL-SX - Manual (Page 6)

6 2034CL-SX, 300 Clip Instant Access System, Sony SX Protocol
Getting Started . . .
3. SYSTEM INSTALLATION
a. SHOTBOX
1)
Plug one end of a standard 9-pin, RS422 serial cable, into the OUTPUT
connector, 9-pin female, on the rear of the SHOTBOX. Plug the other
end of the cable into the 9-pin connector, AUX, on the rear of the
ST300.
2)
Connect the 5 VDC, 1Amp POWER SUPPLY into the POWER connector on
the rear of the SHOTBOX. Plug the Power Supply into an outlet, 90 VAC – 240
VAC.
DO NOT HOT PLUG!
b. ST300-S/SM, VTR/DDR CONTROLLER
1)
Plug one end of a 9-conductor, RS422 serial cable into the 9-pin connector
(VTR 1-4) on the rear of the ST300. Plug the other end of the cable into the 9-
pin REMOTE connector on the SX Hybrid Machine.
2)
Connect the +5, +12, -12 VDC POWER SUPPLY into the POWER connector
on the rear of the ST300. Plug the Power Supply into a wall outlet, 90 VAC -
240 VAC.
3)
Check SETUP MENU prior to using the ST300 to confirm proper Record mode
and other User settable modes.
Installation is complete.