DNF Controls 2034CL-SX - Manual (Page 7)

7 2034CL-SX, 300 Clip Instant Access System, Sony SX Protocol
4. VIDEO SERVER SETUP
a.
When you switch to “Local” mode on the SX, the SX goes to the beginning of the first
clip on the list.
b.
Clips loaded from the front panel of the SX will not be Learned or displayed on the
ST300 or ST420.
c.
The SONY DNW unit must have the following or higher software versions:
1)
SY1-3.22; SY2=3.22:SSX=3.20:SV1=3.20
2) DNW extended menu item 210:DiskProtcl must be V1.0. (Load errors occur
otherwise.)
d. Assuming DNW PLAYER=TAPE, RECORDER=DISK MASTER:
1)
ST300/VTR 1 disk operation.
DNWPB/EE enabled: TC Reader display is from tape when VTR EE mode is
active. During disk PB, TC reader display is from DISK MASTER. Refer to
DNW extended menu item 108 AUTO EE SELECT.
DNW PB enabled: TC reader display is from DISK MASTER only.
2) ST300/VTR2 tape operation: TC reader display is from tape regardless of DNW
PB/EE selection.
e.
SETUP MENU/RECORD MODE. Crash and Lockout are the only modes supported.
Hybrid cannot perform INSERT Edit to either TAPE or DISK MASTER.
5. OPERATION MODE SETUP
On the ST300 setup as follows:
a. Press
[MENU].
b.
Press the VTR [1], [2] [3] or [4] to select the VTR you control the DNW from.
c.
Turn the Wheel until “Player: REC:” is displayed.
d. Press
[MENU] to toggle between the following operation modes of the SX unit:
Player = Ext, REC = Tape Player = Disk, REC = Tape
Player = Ext, REC = Disk Player = Disk, REC = Tape
Player = Tape, REC = Disk
e. Repeat steps b-d to configure all SX units you want to configure.
f. Press
[ESC] at anytime to exit.