Loop clip – DNF Controls 2034CL-Q User Manual
Page 9
9
2034CL-Q, 300 Clip Instant Access System, Quantel Protocol
10. LOOP CLIP
a.
LOAD a clip from CLIPLIST or RECALL a learned clip.
b.
Press [LOOP ENABLE]. The LOOP ENABLE indicator will turn on.
Press [PLAY] to loop a loaded clip. The second line of the display will show “Looping
clip . . .”
OR
Press [SHIFT] + [PLAY]. The clip will be reloaded and start playing in a Loop.
c.
Press [STOP] to stop the loop play. NOTE: The ST300 will NOT respond to any other
keys while a clip is looping. Only [STOP] is recognized in this mode.
NOTES: The LOOP function can be performed on a SINGLE CHANNEL ONLY. Loop
will automatically be disabled if the Channel becomes part of a gang.
If the clip ID ends with an asterisk (“*”), it will automatically loop when either [LOOP
ENABLE] or [PLAY] is pressed.